Filter
Top Products
on the barrel. Before loading your gun be sure all grease
and oil has been removed from the barrel and chamber,
and there is no obstruction.
The rifle chamber is loaded by operating the finger lever,
transferring a cartridge that has been previously placed in
the magazine. To load the magazine, first place the ham-
mer in the safety (half-cock) position.
Twist the magazine tube plug to unlock and pull the tube
out until the colored follower clears the loading port in
the outer magazine tube. With the muzzle pointed
upward, insert the rimmed end of the cartridges into the
magazine (Figure 15) and allow them to slide down
towards the action. Do not exceed the recommended
capacity of the magazine. Next, push the magazine tube
down into position and lock into place.
Care should be taken while pushing the tube in, as it is
under spring tension.
The rifle is now ready for operation.
HOW TO OPERATE
Load the chamber by pivoting the finger lever down fully
and return back to a closed position.
CAUTION: THE HAMMER HAS BEEN AUTO-
MATICALLY MOVED FROM THE SAFETY
(HALF-COCK) POSITION TO THE FULL COCK
POSITION AND IS NOW SET TO FIRE. ALWAYS
PLACE THE HAMMER BACK INTO THE SAFE-
TY (HALF-COCK) POSITION UNTIL YOU ARE
READY TO SHOOT.
When ready to shoot, remove your finger from the trigger
and firmly grip the hammer spur with your thumb, then
carefully draw the hammer back to the full cock position.
Take aim and when on target, squeeze the trigger.
To chamber another round for the next shot, swing the
finger lever down, extracting and ejecting the fired car-
Loading the magazine.
Insert cartridges into
the loading point with
the bullet points
toward the muzzle.
Loading Port
FIGURE 15
13