Filter
Top Products
5
NOTE: Hand tighten bolts and nylon nuts until machine is fully assembled.
Attach the Main Frame (#1) to the Front Stabilizer (#2). Align the holes and secure it with
three M10×5/8" Allen Bolts (#31) and three 3/4" Washers (#39).
Attach the Main Frame (#1) to the Rear Stabilizer (#3). Align the holes and secure it with
two M10×5/8" Allen Bolts (#31) and two 3/4" Washers (#39).
Slide the Sliding Block (#9) onto the Incline Adjustment Bar (#10). Align the holes then
thread in a Knob Lock (#20) to hold the Sliding Block in position.
Push two Bushings (#23) into the Incline Adjustment Bar (#10). Then attach the Bar to the
front bracket on the Main Frame (#1). Secure it with one M10×3" Allen Bolt (#33), two 3/4"
Washers (#39) and one M10 Nylon Nut (#41).
Attach two Bushings (#23) to the side of Main Frame (#1). Attach two Bushings (#23) to
the pivot on top of the Main Frame (#1). Attach two Bushings (#23) to the pivot on the
Sliding Block (#9).
STEP 1
Assembly