Filter
Top Products
Step 1
Slide one Pillow Block Bearing (17) onto each side of the Back Rocker (5). Use two Bolts (33), four Washers
(44), and two Nylon Locknuts (41) to attach each Pillow Block Bearings (17) onto the Main Frame (1).
Slide Short Spacer Tube (12) into the Front Rocker (4). Attach the Front Rocker (4) to the Main Frame (1)
using one Bolt (34), two Washers (44), and one Nylon Locknut (41).
Insert Long Spacer Tubes (11) into the top of Front and Back Rocker (4 & 5). Attach the Connect Frame (6)
to the top of the Front and Back Rocker (4 & 5). Next, insert two Bushings (29) into each side of the Connect
Frame (6). Next, slide both Long Shafts (13) into Connect Frame (6) and secure in place by using four Washers
(44) and four Nylon Lock-nuts (41).
Assembly
7
Figure 1