Filter
Top Products
ASSEMBLY
NOTE: Hand tighten bolts and nylon nuts until STEP 8.
STEP 3
NOTE: Before completing any other
steps, you should position each side
of the unit where it will stay once fully
assembled such that the total length
is 12 feet long. This will keep you
from having to move the unit once it
is loaded with weights.
Slide Weight Bumpers (38) and
Guide Rods (9) into holes of Middle
Base (2).
Slide quantity 9 of the 10 lb plates
(33) onto guide rods. Then slide
quantity 10 of the 5 lb plates (34)
onto guide rods.
Slide Top Plate (32) onto top of
weight stack.
Repeat STEP 3 on other side.
[