Filter
Top Products
7
Figure 1
Figure 3
Assembly Instructions
Moving
See Figure 3 (ELITE ONLY)
CAUTION! TO AVOID THE RISK OF INJURY, NEVER ATTEMPT TO MOVE THE TREADMILL
WHILE IT IS IN THE UNFOLDED OPERATING POSITION. TO REDUCE THE POSSIBILITY OF
INJURY WHILE LIFTING, BEND YOUR LEGS AND KEEP YOUR BACK STRAIGHT. AS YOU
RAISE THE TREADMILL, LIFT USING YOUR LEGS, NOT YOUR BACK. IN ORDER TO RAISE
OR LOWER THE TREADMILL SAFELY, YOU MUST BE ABLE TO LIFT 45 POUNDS (20KG). IT IS
SUGGESTED YOU ALWAYS USE THE AID OF A SECOND PERSON WHEN MOVING THE
TREADMILL.
With the treadmill in the folded locked position (safety latch is engaged), grasp the handrails and place one foot on the base as
shown in the photo below. Next, with a firm grasp on handrails, place one foot on the center of the base crossbar and careful-
ly tilt the treadmill back until it rolls freely on the wheels. Using extreme caution, move the treadmill to the desired location.
To set the treadmill down, place one foot on the center of the base crossbar and carefully lower treadmill onto base in resting
position. Do not attempt to move the treadmill over an uneven or rough surface.
The CLUB HR T Treadmill is shipped in four pieces and the ELITE MAX Treadmill is shipped in two pieces
to make assembly easy. After opening the box, remove any packing materials from the treadmill. You should
find a rear endcap (large plastic piece that fits over the rear roller area), and owner’s manual packet with bolts
and screws for assembly. Do not throw away any packing materials until the unit is working properly. Place
the base on a clean, level surface. Make sure the electrical cord will easily reach an electrical outlet.
Figure 1 – Assembly for main uprights (CLUB ONLY)
1) Have a second person raise the console to the upright position and hold.
2) Insert 3/4” Button Head Bolt into upright bracket and tighten loosely. Repeat for opposite side.
3) Insert the TUBE SPACER inside the upright frame and line up with the bottom hole. Hold tube spacer
while inserting the 1 1/2” Button Head Bolt and lightly tighten. Repeat for opposite side.
4) After completing opposite side, tighten all four assembled bolts and the two other button head bolts that
were present before starting. Assembly is now complete.
5) Be sure to insert the SAFETY KEY before turning the power on.
Figure 2 – Assembly for rear end cap (ELITE & CLUB)
To attach the rear end cap:
1)Place plastic rear end cap over exposed rear roller area.
2)Align holes in plastic end cap with pre-drilled holes in frame.
3)Loosely tighten each screw until all four screws are lined up.
Tighten all four screws snugly.
CAUTION: DO NOT OPERATE TREADMILL WITHOUT SECURING REAR ROLLER HOUSING!!!
Be sure the treadmill is level to the floor. The rear feet can be adjusted to level the treadmill.
Assembly is now complete!
Figure 2