Filter
Top Products
7
Assembly Instructions
The CARDIOZONE ELITE PLUS HR T is shipped in two pieces, please see assembly instructions below.
After opening the box, remove any packing materials from the treadmill. Do not throw away any packing
materials until the unit is working properly. Place the base on a clean, level surface. Make sure the electrical
cord will easily reach an electrical outlet.
Assembly
See Figure 1
To attach End cap:
Place plastic end cap over exposed rear roller area.
Align holes in plastic end cap with pre-drilled holes in frame.
Loosely tighten each screw until all four screws are lined up.
Tighten all four screws snugly.
Moving
See Figure 2
CAUTION! TO AVOID THE RISK OF INJURY, NEVER ATTEMPT TO MOVE THE TREADMILL
WHILE IT IS IN THE UNFOLDED OPERATING POSITION. TO REDUCE THE POSSIBILITY OF
INJURY WHILE LIFTING, BEND YOUR LEGS AND KEEP YOUR BACK STRAIGHT. AS YOU
RAISE THE TREADMILL, LIFT USING YOUR LEGS, NOT YOUR BACK. IN ORDER TO RAISE
OR LOWER THE TREADMILL SAFELY, YOU MUST BE ABLE TO LIFT 45 POUNDS (20KG). IT IS
SUGGESTED YOU ALWAYS USE THE AID OF A SECOND PERSON WHEN MOVING THE
TREADMILL.
With the treadmill in the folded locked position (safety latch is engaged), grasp the handrails and place one
foot on the base as shown in the photo below. Next, with a firm grasp on handrails, place one foot on the
center of the base crossbar and carefully tilt the treadmill back until it rolls freely on the wheels. Using
extreme caution, move the treadmill to the desired location. To set the treadmill down, place one foot on the
center of the base crossbar and carefully lower treadmill onto base in resting position. Do not attempt to
move the treadmill over an uneven or rough surface.
Figure 1
Figure 2