Filter
Top Products
The CardioZone Club Max HR T treadmill is shipped in two pieces to make assembly easy. After opening the
box, remove any packing materials from the treadmill. You should find a rear endcap (large plastic piece that
fits over the rear roller area), and owner’s manual packet with bolts and screws for assembly. Do not throw
away any packing materials until the unit is working properly. Place the base on a clean, level surface. Make
sure the electrical cord will easily reach an electrical outlet.
Assembly for main uprights
1) Raise the console into an upright position and loosely install both 1” button-head screws. Then install the
3.5” x 5/16” bolts (2) with washers (2) and secure using 5/16” nyloc nuts (2). (See Diagram 1 on page 8)
2) Next, tighten both 1” button-head screws and the flathead screws that are already installed and located on
the inside of the upright.
3) Install motor hood cover using 5/8” phillips head screws (8 screws) (See Diagram 1).
Handlebar installation.
4) Handlebars include toggle switches for speed and incline and also EKG pulse grips. Incline toggle switch is
on the left (as you stand on the treadmill). Plug in all wire harnesses for each side and push excess wire into
holes (See Diagram 2 on page 8). The EKG wire harness connects on both sides of handlebar assembly.
Connect the corresponding wire to connector as shown on page 9.
5) Attach left and right handlebars with 5” all thread bolts. Loosely tighten (See Diagram 3 on page 8).
6) Loosely attach bottom side of handrails to uprights with 1” button head screws (See Diagram 3).
7) Install cross handlebar with 2 ½” button screws (See Diagram 3).
8) Securely tighten all handrail bolts and screws.
CAUTION: DO NOT OPERATE TREADMILL WITHOUT SECURING REAR ROLLER HOUSING!!!
Be sure the treadmill is level to the floor. The rear feet can be adjusted to level the treadmill.
Assembly is now complete!
7
Assembly Instructions