Filter
Top Products
WARNING! Do not over-tighten rollers! This will cause pre-
mature roller bearing failure!
Belt adjustment and tension performs two functions: adjustment
for tension and centering. Your new treadmill comes pre-adjusted
from the factory for tension and centering. Please follow the pro-
cedures below if the belt shifts to the left or right while walking:
WALKING BELT IS SHIFTING TO THE LEFT
First, turn treadmill on to run at 1 mph. Using the hex key provid-
ed, turn the left rear roller adjustment bolt ¼ turn in the clockwise
direction. Next, run the treadmill at 2.5 mph. You should see the
belt start to correct itself by moving back towards the center.
Repeat the above procedure until the walking belt is centered. It
may be necessary to set walking belt tension once you have complet-
ed this procedure if the belt feels like it is slipping while walking.
Refer below to the “Walking Belt Slipping” instructions.
WALKING BELT IS SHIFTING TO THE RIGHT
First, turn the treadmill on to run at 1 mph. Using the hex key pro-
vided, turn the right rear roller adjustment bolt ¼ turn in the clock-
wise direction. Next, run the treadmill at 2.5 mph. You should see
the belt start to correct itself, moving back towards the center.
Repeat the above procedure until the walking belt is centered. It
may be necessary to set walking belt tension once you have complet-
ed this procedure if the belt feels like it is slipping while walking.
Refer below to the “Walking Belt Slipping” instructions.
WALKING BELT IS SLIPPING DURING USE
First, unplug the power cord from the surge protector. Using the
hex key provided, turn both left and right rear roller adjustment
bolts the same distance, usually a ¼ turn in the clockwise direction.
Plug the power cord back into the surge protector and run the
treadmill at 2.5 mph. You should now walk on the belt to determine
if the belt is still slipping. Repeat the above procedure until the
walking belt is not slipping. The tension should be just tight enough
not to slip.
Turning the hex key counter clockwise brings the rear rollers and
belt towards you.
Turning the hex key clockwise pushes the rear roller and belt
away form you.
13
Belt Adjustment and Tension
Figure 1
Figure 2
Figure 3