Filter
Top Products
PROGRAM MODE
Plug treadmill into a surge protector outlet. Attach the Red Safety Key on to the treadmill console.
Stand on the treadmill and straddle belt. Attach safety key clip to your clothes.
Press POWER button. There will be an eight (8) second delay before data can be entered. The
TIME window will flash.
There are three (3) pre-set and six (6) semi-custom pre-set programs on the ALL800. The treadmill
includes FAT BURN, CARDIO, and WARM-UP programs. To select the program press the MODE
button until desired program is illuminated on console.
Press START/STOP button. Belt will begin to move after 4 seconds. Step on belt slowly after the
belt starts moving.
CUSTOMIZING PROGRAMS in P1 and P2 Mode: Each pre-set program(Fat Burn, Cardio,
Warm-up, ) can be customized in the P1 or P2 mode. After making the program selection, the
CAL/DIST window will read “OP”. The “OP” refers to “original program” and is preset. The pro-
gram name you select will display in the diode light above the program name. Press the MODE
button once more and the CAL/DIST window will read P1. The “P1” mode is now accessed. You
can now program the Time, Speed, and Incline in P1 mode, which will be saved for future workouts.
1) The TIME window will blink. Use the SPEED + or – arrows to select your workout time. Press
ENTER PROGRAM.
2) The SPEED window will then blink. Use the same + or – arrows to select the speed for your
workout. Press ENTER PROGRAM.
3) The INCLINE window will then blink. Use the INCLINE + or – arrows to set your workout
incline. Press ENTER PROGRAM.
To start, press the START/STOP button. To access P2 mode, press the MODE for desired pro-
gram, then press the MODE button again (once for OP, twice for P1, three times for P2). Follow the
above steps 1-3 to customize P2 settings.
TO CHANGE A PREVIOUSLY PROGRAMMED P1, P2, or user program: Once you have
programmed the P1 or P2 modes, you will need to use the PAUSE button to change the program
you previously entered. For instance to change to a new setting in P1-FAT BURN, press the MODE
button to access FAT BURN , then twice to access P1. Then press the PAUSE button to get the
TIME window to flash. Follow the directions above to continue to change the program.
11
FAT BURN
CARDIO WARM UP
START/STOP
POWER
PAUSE
INCLINE
SPEED
ENTER
Program and Operating Instructions
MODE