Filter
Top Products
6
Assembly Instructions
USA
GB
considerably affect your safety during the ride.
■ Attention: Never park the bicycle with the child still in its seat.
■ Attention: Do not use the seat if one of its components is defective. Damaged components may jeopardize your
or the child’s safety. Before going on a ride you should check all components for potential damage and loose
connections (screws, connections, safety belts etc.). Damaged or worn components must be replaced immedia-
tely. Only use original KETTLER spare parts.
■ Attention: In case of extreme weather conditions please check if the seat can be used by the child, as for ex-
ample the seat may become very hot when there is strong solar radiation, or if the temperature is far below fre-
ezing point the skin may stick to the seat or its components.
Assembly
■ The child’s seat must be positioned such that it is not in contact with the luggage carrier. The distance between
luggage carrier and tube shackle must be min. 25 mm.
■ Fix the tube shackle parallel to the ground. This results in a seat which is slightly inclined towards the rear such
that the child may not slide out of the seat. The seat back is slighty inclined to the rear.
■ The load centre (marked by a red point) may only be within 10 cm behind the wheel hub (explained in detail
below).
■ In case of saddles with uncovered springs the latter have to be covered as a protection against bruises (e. g.
art. nr. 08947-690).
■ Further to that the rear wheel is provided with an additional cover on the spokes or a protective device to pre-
vent dresses from getting mingled with the spokes.
■ Tighten all screws with a torque of approx. 6 Nm. Check the tight fit of all screwed connections after assembly.
■ Please check whether all parts of the bike operate correctly with the set fitted in place (e.g. steering and bra-
kes).
Service and maintenance
■ Always use environmentally friendly substances, never aggressive or caustic ones, for cleaning and servicing
the child’s bicycle seat.
■ If necessary you may also clean the safety belts. In this case it is especially important not to use aggressive sub-
stances! Usually weak washing-up water or a mild detergent will be sufficient.
■ If seat or clothes are damp the colour of the seat may possibly mark pale coloured clothes due to friction.
Accessories
■ If you want to attach the seat to another bicycle, you can order a second carrier for the child’s seat. (item no.
8947-633).
■ To secure the child’s seat from theft, a cylinder lock can be inserted into the seat support bracket. The lock (type
K.01.32.G1) is not supplied with the seat. The lock is obtainable from: Firma P.C. Fischer, Kaiserstraße 126, D-
58300 Wetter/Ruhr, tel. (0) 23 35/42 64, fax (0) 23 35/58 46
Note on Assembly
Assembly must be carried out carefully by an adult.
Carefully read these mounting instructions before beginning with the work itself. The individual steps are additio-
nally explained in the sequence of figures by means of symbols, in some cases a text mark indicates that a writ-
ten explanation is available. Strictly follow the individual mounting steps to ensure a safe use and operation of the
unit.
For technical reasons, we reserve the right to carry out preliminary assembly work (e.g. addition of tubing plugs).
3 Years Guarantee
■ KETTLER guarantees that this product has been manufactured with the greatest care using materials of the highest
quality. However, should you have reason for complaint, please contact your dealer. Do not forget to submit your