Filter
Top Products
Page
ASSEMBLY STEPS
Read through all assembly steps carefully before beginning to assemble the tent. Refer to drawings for clarification. It is
recommended that two people assemble this tent together.
A 9/16" socket and ratchet, or box-end wrench are required for assembly. Wear gloves while you assemble the tent. The
trampoline will be used as an assembly “table” to keep the tent off the ground and to provide a frame of reference.
Remove any ladders or anything on the trampoline that will hinder assembling the tent on the trampoline mat (bed) or
frame.
Top view
Step 1:
First verify that you have received all the tent parts.
Use the shipping container to keep all the hardware
together.
You should have the following pieces:
(see page 15 for details). If you do not have the
required parts then contact your dealer or JumpKing
before proceeding (see page 14).
2 - pole attachment bracket assemblies.
2 - sliding - pole attachment pieces.
2 - long poles.
1 - short pole.
1 - tent with attached tie string pouch.
1 - tent floor.
1 - stuff sack
FIGURE 2
Shock cord
Insert
Pole sections
Make sure the frame pad is installed and secured
properly to the trampoline top frame. First place the
circular tent floor on the trampoline mat (bed). Attach
the plastic hooks to the end of the springs where they
attach to the "v" ring on the mat. Attach one hook and
then stretch the floor and attach the next hook to the
closest spring - continue this process evenly around the
circumference of the mat. The tent floor must cover the
mat (bed) smoothly and evenly (see Fig. 1).
FIGURE 1
Assemble the three poles by joining the sections to-
gether. These are slip joints. Do not force these joints
together. The internal shock cord holds the poles
somewhat rigidly together (see Fig. 2). Be careful of the
pole ends as they are a potential hazard (over head
power lines, eyes) and are not easily controlled due
to the pole length and flexibility. After assembly they
should be placed on the ground. After assembling the
poles you should have two (2) long poles and one (1)
shorter pole. The short pole is the middle support pole.
One pole will have a yellow sticker on each end. This
is the 12 o'clock pole.
Step 3:
Plastic hook to spring end
at "v" ring.
8
Step 2: