Filter
Top Products
9
Step 3: Console Assembly
1. Lay the console on the console tube and connect harnesses.
Do not pull a lot of
wire out of
the handlebars as it may be difficult tucking the excess wire back into the handle
bars. It is
helpful to have someone hold the console while making these connections.
(a) Connect the 5-pin connector from the console to the 5-pin connector coming from the handlebar.
(b) Connect the 2 sets of 3-pin connectors together.
Just match the colors of the wires for
this connection.
(c) Connect the 2 sets of 2-pin connectors together. These are the pulse grip wires so it
doesn’t matter which side gets plugged to either connector out of the console.
2. Carefully tuck excess wire back into the console and the handlebars and lay the console in
place. Do not pinch the wires between the console and the mounting plate.
3. Install the screws into the console thru the console mounting plate and into the console.
The TR500 has 4 mounting screws and the TR1000-TV has 6 mounting screws.
Warning:
Make sure no cables or wires are pinched when the console screws are tightened.
Step 4: Complete Assembly
Make sure the console bracket and the plastics fit properly (FIG-6 & 7). Tighten 4 bolts M
under both sides of the console tube (FIG-8).