Filter
Top Products
Assembly
7
FIGURE 3:
Step 1:
Slide the Plastic Bellow (14) onto the
Console Tube (2).
Step 2:
Connect the Console Cable (7) to
Sensor Wire (36). Connect the
Resistance Cable (73) to the Cable
from the Console Tube (Figure 3a-c).
Step 3:
Using Six M8x18mm Washers (72)
and M8x15mm Screws (63), Attach
the Console Tube (2) to the Main
Frame( 1). Slide the Plastic Bellows
down until it meets the Main.
Assembly. Secure using M4x16mm
Screw (19)
FIGURE 3a: Connect the Tension Knob to the Resistance Cable. Fit the Resistance Control
Cable into the slot of the Tension Knob. Pull the brass end of the Resistance Control Cable over
the lip of the Tension Knob Bracket. The connection should look like Figure 3c when completed.
3a 3b
3c
Figure 3
FIGURE 4
Step 1:
Pull the Hand Pulse Wires (25a)
coming from the Front Handlebar (5)
through the Console Tube. Attach
Front Handlbar (5) to Console Tube
using Two M8x45mm Screws (23),
Three M8x19mm Washers (50), Two
8mm Acorn Nuts (13), and One
M8x15mm Screw (63).
Figure 4