Filter
Top Products
12
CONSOLE FUNCTIONS
TIME:
If a target time was not selected, time will count up from 00:00 to maximum 99:59. When
working out with a target time, time will count down from target to 00:00. When selecting
target time, use the +/- buttons, the time will change in 1 minute increments and can range
from 1:00 min to 99:00 mins.
SPEED:
Displays current training speed from 0.0 to maximum 99.9 KM or MPH.
RPM:
Displays current training revolutions per minute.
DISTANCE:
If a target distance was not selected, distance will count up from 0.00 to maximum 99.90.
When working out with a target distance, distance will count down from target to 0.0. When
selecting target time, use the +/- buttons, the distance will change in 0.1 mile increments and
can range from 0.00 miles to 99.90 miles.
CALORIES:
If target calories were not selected, calories will count up from 0 to maximum 990. When
working out with target calories, calories will count down from target to 0. When selecting
target calories, use the +/- buttons, the calories will change in 10 calorie increments and can
range from 0 calories to 990 calories.
PULSE:
Displays your current heart rate as soon as both hands are holding the pulse sensor. The mon-
itor will detect your heart rate through hand grip sensors that are located on the upright and
near the seat. Note: It may take several seconds for the electronics to detect and display an
accurate heart rate reading.
WATT:
Displays current training watt figures. A watt is a measurement of the amount of power gener-
ated by the user based on the resistance and speed.
RECOVERY:
After your workout, keep holding on hand grips and press “RECOVERY” button. All function
display will stop except “TIME” starts counting down from 01:00 to 00:00. Screen will display
your heart rate recovery status rating between F1-F6. F1 is the best, F6 is the worst. User
may keep exercising to improve the heart rate recovery status. (Press the RECOVERY button
again to return the main display.)
CALENDAR:
Screen will display year/month/day in sleep mode. When the unit is plugged in the console will
prompt user to input correct information. Use the UP and DOWN button until correct year is
found. Press MODE/ENTER to confirm selection. Repeat steps to input correct month and day.
Note: All information will be saved until unit is unplugged.
Console Instructions