Filter
Top Products
SECTION 2—OPERATION
MA50 Series 20 Part No 1148136
Transferring Patient From/To a Wheelchair
ƽ WARNING
ALWAYS engage the wheel locks of the bed and the wheel locks of the wheelchair
before transferring the patient between the bed and the wheelchair.
1. Engage the wheel locks of the bed. Refer to the owner’s manual provided with the bed.
2. Engage the wheel locks of the wheelchair, if applicable. Refer to the owner’s manual
provided with the wheelchair.
3. Press the Max Inflate or Mode button to achieve maximum mattress pressure.
4. Raise or lower the bed to match the wheelchair height. Refer to the owner’s manual
provided with the bed.
5. When the mattress has reached maximum firmness, perform one of the following:
• Bed to Wheelchair Transfer - Slide the patient onto the wheelchair.
• Wheelchair to Bed Transfer - Slide the patient onto the bed.
Preparing for CPR Procedure
NOTE: For this procedure, refer to FIGURE 2.6.
1. Press and hold the tabs on hose connector while pulling the hose from the control unit.
2. Disconnect the RED CPR connector located on the side of the mattress.
FIGURE 2.6 Preparing for CPR Procedure
About Power Outage and Transportation
If the hoses remain connected to the control unit, the mattress retains air during a power
outage, during transportation, when the control unit is unplugged or when the control
unit is turned Off. If the hose becomes disconnected or damaged and the mattress
deflates, the mattress has a 2-inch foam pad to provide patient support .
RED CPR
Connector
Mattress
Hose
Connector
Hose
Control Unit Connectors
Tab