Filter
Top Products
SECTION 2—OPERATION
MA50 Series 10 Part No 1148136
SECTION 2—OPERATION
CAUTION
The control unit and mattress on the MA50 series are designed to be used as a
system. DO NOT replace mattresses or control units with other models or other
brands. Otherwise, damage to the system may occur. Contact your supplier to get
the correct replacement if needed.
Installing the Mattress
Overlay System (MA50)
NOTE: For this procedure, refer to FIGURE 2.1.
NOTE: The overlay system comes with the following straps - head end elastic strap, foot end elastic
strap and two buckle straps.
1. If necessary, lower the side rails to facilitate installation of the mattress.
2. Place the mattress overlay directly over the existing 3 to 5-inch foam mattress.
3. Loop the head end elastic strap around the head end of the existing foam mattress.
4. Loop the foot end elastic strap around the foot end of the existing foam mattress.
5. Secure the overlay mattress to the existing foam mattress using the two buckle straps.
NOTE: Ensure that the side rails can move freely.
FIGURE 2.1 Installing the Mattress - Overlay System (MA50)
Mattress
Overlay
Foam
Mattress
Head End
Elastic Strap
Foot End
Elastic Straps