Filter
Top Products
STEP 2 (SEE DIAGRAM 2)
A.)
Connect the Main Seat Support (#1) to the Rear Stabilizer (#14). Secure them with
one Bracket (#17), two M10 x 3 ¾” Carriage Bolts (#47),
∅
7/8” Washers (#48) and
M10 Aircraft Nuts (#50).
B.) Connect the Main Seat Support (#1) to the Front Stabilizer (#56). Secure them with
one Bracket (#17), two M10 x 3 ¾” Carriage Bolts (#47),
∅
7/8” Washers (#48) and
M10 Aircraft Nuts (#50).
C.) Slide the Sliding Block (#10) onto the Chromed Incline Adjustment Bar (#11). Align
the holes then thread a Pull Pin (#37) into the hole to hold the Sliding Block at the
position.
D.) Attach two Bushings (#54) to the Chromed Incline Adjustment Bar (#11). Then
attach the Bushings and Bar to the bracket on the Main Seat Support (#1). Secure
it with one M10 x 3” Allen Bolt (#41), two
∅
7/8” Washers (#48), and one M10
Aircraft Nut (#50).
DIAGRAM 2
5