Filter
Top Products
ASSEMBLY INSTRUCTION
Tools Required Assembling the Machine: Two Adjustable Wrenches
NOTE: It is strongly recommended two or more people assembling this machine to
avoid possible injury.
STEP 1 (See Diagram 1)
A.) Plug the two Stabilizer End Caps (#24) onto the bottom of the two Rear Upright
Beams (#1).
B.) Connect the two Rear Upright Beams by a Cross Brace (#2) in the Mid-span. Secure
them with two M8 x 3 1/8” Hex Bolts (#27), four ∅ 5/8” Washers (#28), one Curved
Bracket (#3), and two M8 Aircraft Nuts (#29) on each end of the Cross Brace.
C.) Insert the Backrest Adjustment Bar (#4) through a selected hole to obtain desired
incline of Backrest.
Diagram 1
4