Filter
Top Products
STEP 5 (See Diagram 5)
A.) Place a Seat Pad (#8) onto the Left Seat Support (#5). Secure the front hole on the Left
Seat Support with one M10 x 3 3/8” Allen Bolt (#25), Ø ¾” Lock Washer (#29), and Ø ¾”
Bent Washer (#26). Secure the rear hole with one M10 x 4 1/8” Allen Bolt (#24), Ø ¾” Lock
Washer (#29), Ø ¾” Washer (#27), and Rubber Bumper (#14).
B.) Attach the Handle Cover (#10) to the tube on the Left Seat Support. Align the holes and
insert the Handlebar (#9) halfway through the tube. Push two Handlebar Grips (#11) onto
the tube from both ends.
C.) Repeat Procedures A & B above to install the other side.
D.) To lock the Teeter Totter while not in use, align the end of the Cable Strap to the open
bracket underneath the Right Seat Support then insert the L-shaped Lock Pin (#18) through
the holes. Remove the Pin when ready to use the Teeter Totter.
10