Filter
Top Products
STEP 7 (See Diagram 7)
A.) Attach the Front Vertical Frame (#54) to the Rear Stabilizer (#53). Secure it with two M10 x 5/8”
Allen Bolts (#88) and ∅ ¾” Washers (#42). Do not tighten all the nuts and bolts yet.
B.) Attach the Cross Brace (#48) to the Left & Right Supports (#50 & 51). Secure each end of Cross
Brace with two M10 x 3 1/8” Carriage Bolts (#82), one 5” x 1 5/8” Bracket (#64), two ∅ ¾”
Washers (#42), and two M10 Aircraft Nuts (#44).
C.) Attach the Rear Vertical Frame (#52) to the rear bracket on the Front Vertical Frame (#54) and
the Cross Brace (#48). Secure it to the Front Vertical Frame with two M10 x 5/8” Allen Bolts
(#88) and ∅ ¾” Washers (#42). Secure it to the Cross Brace with two M10 x 2 3/8” Carriage
Bolts (#80), one 4 3/8” x 2 3/8” Bracket (#65), two ∅¾” Washers (#42) and M10 Aircraft Nuts
(#44). Securely tighten all nuts and bolts previously installed.
D.) Insert two Weight Posts (#63) to the holes on the Left & Right Supports (#50 & 51). Secure each
Weight Post with one M10 x 5/8” Allen Bolt (#88) and ∅¾” Washer (#42). Slide an Olympic
Sleeve (#20) onto each Weight Post. Attach a Spring Clip (#22) to the Olympic Sleeve.
E.) Insert the Left & Right Bar Holders (#93 & 92) into the selected holes on the Upright Beams.
Insert the Left & Right Safety Catches (#58 & 59) into the selected holes on the Upright Beams.
11