STEP 2 (See Diagram 2)
A.) Note: In able to hold the Handlebar Post (#4) while connecting the cables and wires,
extra help may be needed. Attach the Handlebar Post (#4) to the Main Frame (#1).
Connect the Middle Computer Sensor Wire (#24) from the bottom of Handlebar Post to
the Lower Computer Sensor Wire (#25) from the main body of the bike.
B.) Slide the cable wire from the Upper Tension Connector (#23) in between the opening
on the wire holder on the Lower Tension Connector (#26). Pull the Upper Tension
Connector upward and slide the wire through the slot on the bracket.
C.) Drop down the Connector so the fitting sits firmly on top of the bracket.
D.) Secure the Handlebar Post to the Main Frame with three M8 x 5/8” Allen Bolts (#18)
and Ø 7/8” Bent Washers (#19).
E.) Connect Middle Computer Sensor Wire (#24) to the Upper Computer Sensor Wire
(#30). Slide the Computer (#6) onto the plate on the Handlebar Post.
F.) Connect the Handlebar (#5) to the Handlebar Post (#4) and secure it with three M8 x
5/8” Allen Bolts (#18) and ∅5/8” Washers (#20).
6