Filter
Top Products
STEP 6 (See Diagram 6)
A.) Attach a Pulley (#58) to the front opening on the Upper Frame (#10). Attach the 133”
Upper Cable (#29) to the Pulley. Secure the Pulley with one M10 x 2 ½” Allen Bolt
(#93), two Ø 1” x 5/8” Pulley Bushings (#77), and one M10 Aircraft Nut (#82). Make
sure the ball stopper on the Cable is underneath the Upper Frame.
B.) Draw the Cable over the Pulley along the Upper Frame towards the back of the
machine to the open bracket on the Upper Frame.
C.) Attach a Pulley to the bracket. Secure it with one M10 x 1 ¾” Allen Bolt (#94), two ∅
¾” Washers (#80), and one M10 Aircraft Nut (#82).
D.) Draw the Cable around the Pulley then downward. Attach the Cable to the Double
Floating Pulley Bracket (#18). Repeat C above to install a Pulley to the Bracket.
E.) Draw the Cable around the Pulley then upward to the open bracket underneath the
Upper Frame. Install a Pulley to the bracket. Let the Double Floating Pulley Bracket
hanging for now.
F.) Draw the Cable around the Pulley then downward. Attach the Cable to a Single
Floating Pulley Bracket (#19). Install a Pulley to the Bracket. Draw the Cable around
the Pulley then upward to the opening on top of the Rear Vertical Frame (#6). Let the
Single Floating Pulley Bracket hanging for now.
G.) Attach a Pulley to the opening. Secure it with one M10 x 2 3/8” Allen Bolt (#95), two
Ø 1” x ½” Pulley Bushings (#76), and one M10 Aircraft Nut (#82).
H.) Draw the Cable around the Pulley and downward to the bracket on the Sliding
Weight Post (#11). Secure the Cable to the bracket with one M10 x ¾” Allen Bolt
(#97), two ∅ ¾” Washer (#80) and one Aircraft Nut (#82).
I.) Connect the Lat Bar (#22) to the ball stopper on the Upper Cable with one Long
Chain (#55) and two Hooks (#54).
15