Filter
Top Products
ASSEMBLY INSTRUCTION
Tools Required to Assemble the Machine: Two Adjustable Wrenches and Allen
Wrenches. NOTE: It is strongly recommended this machine to be assembled by two or
more people to avoid possible injury.
STEP 1 (See Diagram 1)
A.) Connect the Left and Right Upright Beams (#1) & (#2) by a Cross Brace (#4) in the mid-
span. Align the holes and secure them with one Bracket (#23), two M10 x 3 1/8” Carriage
Bolts (#39), two ∅ ¾” Washers (#50), and M10 Aircraft Nuts (#49) on each end of the
Cross Brace.
B.) Place Backrest Adjustment Bar (#12) between the two Upright Beams on the selected bar
holder to obtain desired incline of Backrest.
C.) Insert two Crutches (#7) into the top openings on the Upright Beams. Secure them with
two Lock Knobs (#37) through selected holes to obtain desired height of the Supports.
D.) Insert the Left and Right Safety Hooks (#53) & (#54) into the holes on the Crutches (#7).
Secure them with two M8 Aircraft Nuts (#38).
E.) Attach a Weight Plate Holder (#14) onto the back of the Left Upright Beam (#1). Secure it
with a M10 x 1” Allen Bolt (#55) and ∅3/4” Washer (#50). Push a Rubber Bumper (#20)
onto the Holder (#14). Repeat the step to install the other side.
DIAGRAM 1
4