Filter
Top Products
ASSEMBLY INSTRUCTION
Tools Required Assembling the Machine: Two Adjustable Wrenches and Allen Wrenches.
NOTE: It is strongly recommended two or more people assembling this machine to avoid
possible injury.
STEP 1 (See Diagram 1)
A.) Connect the two Rear Upright Beams (#1) by a Cross Brace (#2) in the mid-span. Align the
holes and secure them with one Weight Post (#3), three M10 x 3 1/8” Carriage Bolts (#36),
three ∅ ¾” Washers (#43), and three M10 Aircraft Nuts (#46) on each end of the Cross
Brace.
B.) Insert two Crutches (#4) into the top openings on the Upright Beams. Secure them with two
Lock Knobs (#20) through selected holes to obtain desired height of the Supports.
C.) Place Backrest Adjustment Bar (#14) between the two Upright Beams on the selected bar
holder to obtain desired incline of Backrest
D.) Attach a Spring Clip (#21) onto each Weight Post.
DIAGRAM 1
4