Filter
Top Products
STEP 3 (See Diagram 3)
A.) Attach the Leg Developer (#9) to the Leg Developer Holder (#8). Secure it with one M8 x 3
1/8” Allen Bolt (#37), two ∅ 5/8” Washers (#33), and one M8 Aircraft Nut (#34).
B.) Insert one Foam Tube (#10) halfway through the hole on the Leg Developer Holder and two
Foam Tubes halfway through the two holes on the Leg Developer (#9).
C.) Push six Foam Rolls (#21) onto the Tubes from both ends. Attach a Spring Clip (#27) onto
the weight post on the Leg Developer.
DIAGRAM 3
6