Filter
Top Products
ASSEMBLY INSTRUCTION
Tools required to assembly the machine:
Two Adjustable Wrenches
STEP 1 (SEE Diagram 1)
A.) Connect the two Rear Upright Beams (#1) by a Cross Brace (#25) in the Mid-span.
Fasten them by two M10x 2 3/8” Bolts (#14), four ∅ 7/8” Washers (#13), one Bracket
(#12), and two M10 Aircraft Nuts (#15) on each side of the Cross Brace. DO NOT
tighten the nuts and bolts yet.
B.) Insert the Backrest Adjustment Bar (#10) through a selected hole to obtain desired
incline of Backrest.
C.) Insert two Bar Catches (#2) & (#6) into the selected hole on the Rear Upright Beams
(#1) to obtain the desired height to hold the weight bar.
DIAGRAM 1
4