Filter
Top Products
STEP 2 (SEE DIAGRAM 2)
A.) Connect the Front Stabilizer (#42) to the Main Seat Support (#52). Secure them with
two M10 x ¾” Hex Bolts (#46), four ∅ ¾” Washers (#3), and two M10 Aircraft Nuts (#4).
DO NOT tighten the nuts and bolts yet.
B.) Connect the Main Seat Support (#52) to the open bracket on the Cross Brace (#15).
Secure them with two M10 x 2 3/8” Bolts (#2), four ∅ ¾” Washers (#3), and two M10
Aircraft Nuts (#4).
C.) Connect one end of Diagonal Support (#43) to the Main Seat Support (#52). Secure it
with one M8 x 2 1/8” Hex Bolt (#48), two ∅ 5/8” Washers (#21) and one M8 Aircraft Nut
(#49). Connect the other end to the Front Stabilizer (#42). Secure it with one M8 x ¾”
Hex Bolt (#20) and ∅ 5/8” Washer (#21).
D.) Securely tighten all the nuts and bolts previously installed.
E.) Insert a Long Lock Pin (#53) into the hole on the Main Seat Support (52). NOTE: The
Pin is not designed to sustain any heavy weight. Only use the pin when changing the
backrest board to a vertical position when doing Walk-in-Squat from the rear.
5