Filter
Top Products
STEP 7 (See Diagram 7)
A.) Attach the Leg Developer (#25) to the open bracket on the Main Seat Support (#18). Secure
it with one M10 x 3 ½” Allen Bolt (#73), two Ø ¾” Washers (#84), and one M10 Aircraft Nut
(#86). Note: Do not over tighten the Nut and Bolt. Make sure the Leg Developer is able
to move smoothly.
B.) Insert two Foam Tubes (#26) halfway through the holes on Leg Developer. Push four Foam
Rolls (#58) onto the Tubes from each end. Plug four Foam Roll End Caps (#55) into the
Ends.
C.) Slide an Olympic Sleeve (#65) onto the weight post on Leg Developer. Attach a Spring Clip
(#44) to the Sleeve.
D.) Attach the Arm Curl Handle (#27) to the bracket on the Leg Developer. Secure it in position
with a Lock Pin (#64).
DIAGRAM 7
13