Filter
Top Products
CAGE ASSEMBLY INSTRUCTION
Tools Required for Assembling the Machine: Two Adjustable Wrenches and Allen
Wrenches.
NOTE: It is strongly recommended that two or more people assemble this machine
to avoid possible injury.
STEP 1 (See Diagram 1)
A.) Attach a Ø 2 ½” Rubber Bumper (#29) and the Weight Storage Post (#14) to Right
Stabilizer (#3). Secure it with one M10 x ¾” Allen Bolt (#50) and Ø ¾” Washer (#52).
B.) Note: Do not tighten the Nuts and Bolts in following steps until instructed to do
so.
C.) Connect the Right and Left Stabilizer (#2 & #3) by the Rear Base Frame (#4). Secure
each end of the Rear Base Frame to each Stabilizer with four M10 x 2 3/8” Carriage
Bolts (#43), one 4 ¾” x 3 ¼” Bracket (#17), four Ø ¾” Washers (#52), and four M10
Aircraft Nuts (#54).
D.) Attach an Upright Beam (#1) onto the Right Stabilizer. Secure it with four M10 x 2 3/8”
Carriage Bolts (#43), four Ø ¾” Washers (#52), and four M10 Aircraft Nuts (#54).
Repeat the same step to install the other Upright Beam to the Left Stabilizer.
E.) Attach the Top Beam (#5) to the two Upright Beams. Secure each end of the Top
Beam with one M10 x 4 1/8” Allen Bolt (#45) to the upper hole, one M10 x 4 1/8”
Carriage Bolt (#40) to the lower hole, one 4” x 2 3/8” Curved Bracket (#16), two Ø ¾”
Washers (#52), and one M10 Aircraft Nut (#54).
6