Filter
Top Products
STEP 5 (See Diagram 5)
A.) Attach two Ø 5/8” Bushings (#20) to the Leg Developer (#10). Attach the Leg Developer
to the Leg Developer Holder (#7). Secure it with one M10 x 3 1/8” Allen Bolt (#36), two Ø
¾” Washers (#41), and one M10 Aircraft Nut (#44).
B.) Insert three Foam Tubes (#13) halfway through the holes on the Leg Developer and Leg
Developer Holder. Push six Foam Rolls (#27) onto the Tubes from both ends. Plug six
Foam Roll End Caps (#26) into the ends.
C.) Slide an Olympic Sleeve (#29) onto the weight post on Leg Developer. Attach a Spring
Clip (#30) onto the Sleeve.
D.) Attach the Arm Curl Pad (#18) to the Arm Curl Stand (#11). Secure it with two M8 x 5/8”
Allen Bolts (#39) and two Ø 5/8” Washers (#42).
E.) Insert the Arm Curl Stand into the Leg Developer holder. Use the M10 Lock Knob (#28) to
lock the Arm Curl Stand in position.
F.) Remove the Arm Curl Stand when doing Leg Developer exercises.
DIAGRAM 5
9