Filter
Top Products
STEP 2 (See Diagram 2)
A.) Attach the Lat Bar Frame Support (#66) onto the joint of the two Base Frames (#65).
Align the holes and secure them together with two M10 x 3 ¾” Carriage Bolts (#46), Ø ¾”
Washers (#39) and M10 Aircraft Nuts (#51).
B.) Attach the Lat Bar Frame Support (#66) to the bracket on the Cross Brace (#69). Attach
the Rear Diagonal Support Frame (#77) to the back of Lat Bar Frame. Align the holes
and secure them together with one M10 x 2 ¾” Carriage Bolt (#47), Ø ¾” Washer (#39)
and M10 Aircraft Nut (#51) to the top holes, one M10 x 2 ¾” Allen Bolt (#20), two Ø ¾”
Washers (#39) and one M10 Aircraft Nut (#51) to the bottom holes.
C.) Slide the Sliding Weight Post (#71) onto the Lat Bar Frame (#70) from the bottom. Insert
the Lat Bar Frame (#70) into the Lat Bar Frame Support (#66). Secure it with two M10 x 2
3/8” Allen Bolts (#48), four Ø ¾” Washers (#39) and two M10 Aircraft Nuts (#51).
D.) Attach an Olympic Sleeve (#14) onto the Sliding Weight Post. Attach a Spring Clip (#15)
onto the Sleeve. Securely tighten all Nuts and Bolts previously installed.
7