Filter
Top Products
STEP 5 (See Diagram 5)
A.) Attach two Ø 5/8” Bushings (#20) to the Leg Developer (#10). Attach the Leg Developer
to the Leg Developer Holder (#7). Secure it with one M10 x 3 1/8” Allen Bolt (#36), two Ø
¾” Washers (#41), and one M10 Aircraft Nut (#44).
B.) Insert three Foam Tubes (#13) halfway through the holes on the Leg Developer and Leg
Developer Holder. Push six Foam Rolls (#27) onto the Tubes from both ends. Plug six
Foam Roll End Caps (#26) into the ends.
C.) Slide an Olympic Sleeve (#29) onto the weight post on Leg Developer. Attach a Spring
Clip (#30) onto the Sleeve.
D.) Thread a M10 Lock Knob into Leg Developer Holder.
DIAGRAM 5
10