Filter
Top Products
STEP 3 (See Diagram 3)
A.) Attach the Chin-up Bar (#10) to the top opening on the two Upper Upright Beams.
Secure the Chin-up Bar to each opening with one M8 x 1 5/8” Allen Bolt (#27) and Ø ½”
Bent Washer (#34). Cover each opening with an Upright Beam End Cap (#30).
B.) Attach the two Arm Pads (#15) onto the Dip Supports. Secure each Arm Pad with two
M8 x 2 ½” Allen Bolts (#16) and Ø 5/8” Bent Washers (#26).
C.) Attach the Backrest Board (#14) to the Cross Brace (#7). Secure it with two M8 x ¾”
Allen Bolts (#29) and Ø 5/8” Washers (#28).
D.) Securely tighten all Nuts and Bolts previously installed.
8