Filter
Top Products
STEP 3 (See Diagram 3)
A.) NOTE: Help of another person is strongly recommended for this step. Place the
Lifting Sleeve (#10) in between the two Sliding Bar Catches (#8). Align the holes
and insert the Weight Bar (#9) into the Bar Catch from one end and through the
Lifting Sleeve to the other Bar Catch on the opposite end. Center the Weight Bar
and secure it to each Bar Catch with one M10 x 5/8” Allen Bolt (#15).
B.) Turn the hook on the Lifting Sleeve into the selected holes on the Upright Beams to
secure the Weight Bar position.
C.) Slide a Ø3” Rubber Spacer (#25) onto the Weight Bar. Push one Long Olympic
Sleeve (#27) onto the Weight Bar. Secure the Olympic Sleeve with a M8 x ½” Allen
Screw (#16). Attach a Spring Clip (#29) onto the Sleeve.
D.) Repeat Step C above to install the other side.
E.) Attached the Shoulder Pad (#28) to the Lift Sleeve (#10).
DIAGRAM 3
7