Filter
Top Products
ASSEMBLY
To hire an authorized service technician to assemble the treadmill, call toll-free 1-800-445-2480.Assembly re-
quires two persons. Set the treadmill in a cleared area and remove the packing materials; do not dispose of the
packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with
high-performance lubricant. During shipping, lubricant may be transferred to the top of the walking belt or to the
shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top
of the walking belt, wipe it off with a soft cloth and mild, non-abrasive cleaner.
Assembly requires the included hex keys and your own phillips screwdriver , rubber
mallet , adjustable wrench , and wire cutters .
To identify assembly hardware, see the drawings below. The number in parentheses below each drawing is the
key number of the part, from the PART LIST in the center of the manual. The number following the parentheses
is the quantity used in assembly.
To avoid damaging plastic parts, do not use power tools for assembly.
1
/2” Screw (119)–1
1
3/4” Tek Screw (58)–8
1
Nut (47)–4
Frame Bolt (32)–2
3/4" Screw (2)–6
Upright Bolt/Wheel Bolt (40)–6
Frame Washer
(33)–2
1/4" Star Washer
(21)–2
Handrail Bolt (20)–4
Silver Ground
Screw (27)–2
Wheel Spacer
(44)–4
Console
Bolt (22)–2
Upright Star
Washer (39)–4
Handrail Star
Washer (19)–4
1. Orient the Base (48) as shown.
Identify the Right Upright (36), which has a
square hole near the lower end.
Orient the Right Upright (36) as shown, and
attach it to the Base (48) with two Upright Bolts
(40) and two Upright Star Washers (39); do not
tighten the Upright Bolts yet.
48
Square
Hole
40
40
39
39
36
1
6