Filter
Top Products
7. Hold the Connector Cover (110) on the Console Base
(87) in the position shown. Attach the Connector Cover
with two 3/4” Screws (68).
68
110
87
8. Remove the Latch Knob (105) from the Latch Pin (11).
Make sure that the Latch Pin Collar (14) and the Spring
(56) are on the Latch Pin as shown. Insert the Latch Pin
into the Storage Latch (77) and tighten the Latch Knob
onto the Latch Pin.
10.Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may
be included. Keep the included allen wrench in a secure place; the allen wrench is used to adjust the walking
belt (see page 23). To protect the floor or carpet from damage, place a mat under the treadmill.
77
9
85
14
56
11
8
7
105
6. Attach the Handrail (85) to the Console Base (87) with
two 1 1/2” Screws (79) as shown. Attach the other
Handrail (not shown) to the other side of the Console
Base in the same way.
Insert the excess Wire Harness (17) down into the Right
Upright (10) as you set the right Handrail (85) on the Right
Upright.
Hand tighten two 4” Bolts (89) with Washers (29)
through the Right Upright into the right Handrail. Be careful
not to pinch the Wire Harness. Do not tighten the Bolts
yet.
Attach the left Handrail (not shown) to the Left Upright
(not shown) in the same way. Note: There is not a wire
harness in the Left Upright.
89
29
10
87
79
85
17
6
8
9. Lower the Uprights (9, 10) until the Handrails (not shown)
touch the floor. Make sure that the treadmill Frame (12)
is centered between the Uprights. See step 3. Firmly
tighten the four 3” Bolts (47). See step 6. Firmly tighten
the four 4” Bolts (89). Raise the Uprights back to the ver-
tical position.
Make sure that the two Cup Holders (118) are pressed
into the round holes in the top of the Console Base (87).
9
10
Top View
9
12
87
118