Filter
Top Products
49
NOTE: A minimum distance of 10 feet will be maintained between the Upper and
Lower Range regardless of the manual settings entered.
Side Beam Range
(WideSide® transducer: WideSide® View only)
Settings: 6 to 160 ft, 2 to 50 m [International Models only];
Default = 160 ft
Side Beam Range sets the deepest range that will be displayed in the
WideSide® View. The range must be set manually to keep the bottom visible on
the display. If the Side Beam Range is set too deep for current depth conditions,
the sonar information will become compressed on the display and valuable
detail will be lost.
The Side Beam Range option is available when a WideSide® transducer is
connected to the Fishing System and Transducer Select is set to WideSide® (see
Sonar Menu Tab: Transducer Select). This option can only be accessed from the
Sonar X-Press™ Menu in the WideSide® View.
NOTE: The Side Beam Range requires the purchase of the WideSide® transducer. You
can visit our Web site at humminbird.com to order this accessory online or contact our
Customer Resource Center at 1-800-633-1468.
Chart Speed
Settings: 1-9, Ultra, where 1 = Slow, 9 = Fast, Ultra =
Fastest; Default = 5
Chart Speed determines the speed at which the sonar information moves across
the display, and consequently the amount of detail shown.
A faster speed shows more information and is preferred by most anglers;
however, the sonar information moves across the display quickly. A slower speed
keeps the information on the display longer, but the bottom and fish details
become compressed and may be difficult to interpret. Regardless of the Chart
Speed setting, the RTS Window™ will update at the maximum rate possible for
the depth conditions. Adjust Chart Speed to your personal preference.
Sonar X-Press™ Menu