Filter
Top Products
9
INTRODUCTION
IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
TREADMILL
OPERATION
CONDITIONING
GUIDELINES
TROUBLESHOOTING
& MAINTENANCE
LIMITED
WARRANTY
Open HARDWARE BAG 2.
Lift the RUNNING DECK until lock
latch on side of treadmill is fully
engaged (See step 1).
Remove CONSOLE from box
and place out of the way
(See step 2).
Lower the treadmill RUNNING
DECK from the folded position
by stepping on LOCK LATCH on
lower left side (See step 3).
With running deck in lowered
position, place CONSOLE on
upright masts.
Place FLAT WASHER (E) and
BOLT (D)
into LEFT upright
MAST and CONSOLE and
lightly tighten.
Gently lift RIGHT side of the
console to connect the CONSOLE
CABLE. Carefully tuck wires in
mast to avoid damage. Note: Do
not pinch console cable. Be sure
the console cable prongs are
aligned and the ends are tightly
seated into each other.
Repeat steps F-G above to
assemble the right side upright
mast and console.
Tighten all bolts completely.
* NOTE: Be careful not to pinch any
wires while assembling the masts.
A S S E M B LY S T E P 2
A
B
C
D
E
F
G
H
I
* Be sure to tighten bolts after all are lined up.
WASHERS (E)
BOLT (D)
ASSEMBLED IN STEP 2-C
BOLT (D)
20 mm
Qty: 4
top view
FLAT WASHER (E)
16 mm Diameter
Qty: 4
HARDWARE BAG 2 CONTENTS :
2
1
3