Filter
Top Products
INTRODUCTION
IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
TREADMILL
OPERATION
LIMITED
WARRANTY
7
DO NOT CUT STRAPS UNTIL STEP 1.4!*
Disassemble box and remove the
DO NOT CUT STRAPS UNTIL STEP 1.4!* Disassemble box and remove the DO NOT CUT STRAPS UNTIL STEP 1.4!*
cardboard packaging that is not beneath the treadmill. Do not attempt to lift the
treadmill at this time. Reach under treadmill running deck to locate parts box.
Remove plastic wrap from console masts.
NOTE:
It is recommended that you apply grease to the threads of each bolt as you assemble your treadmill, to
prevent loosening and noise. Also, during each assembly step, ensure that ALL nuts and bolts are in place and
partially threaded in before completely tightening any ONE bolt.
Lift
LEFT CONSOLE MAST
into
LEFT CONSOLE MAST into LEFT CONSOLE MAST
upright position.
Be sure to hold
the console mast firmly, as it
will not stay in the upright
position on it’s own.
Move
LEFT SIDE LINKAGE ARM
into position. Insert
T
EFLON
TEFLON T
WASHER (B)
(2 pcs) and
WASHER (B) (2 pcs) and WASHER (B)
BOLT
(A)
and tighten.
(A) and tighten.(A)
Repeat on the right side.
Now cut the banding straps and
remove remaining packaging
material.*
Lift the
RUNNING DECK
until
RUNNING DECK until RUNNING DECK
lock latch is fully engaged.
Remove
CONSOLE
from box
CONSOLE from box CONSOLE
and place out of the way.
Lower the treadmill
RUNNING
Lower the treadmill RUNNINGLower the treadmill
DECK
from the folded position
DECK from the folded position DECK
by stepping on LOCK LATCH on
lower right side.
A S S E M B LY S T E P 1
A S S E M B LY S T E P 2
A
B
C
D
A
B
C
P R E - A S S E M B LY
TROUBLESHOOTING
& MAINTENANCE
CONDITIONING
GUIDELINES
* NOTE:
If the straps have been removed before completing
STEP
1, refer to the
TROUBLESHOOTING
section (page 26)
TROUBLESHOOTING section (page 26) TROUBLESHOOTING
in order to restore the treadmill to its proper position.
LEFT CONSOLE MAST
LEFT SIDE LINKAGE ARM
BOLT A
1
3
2
WARNING