Filter
Top Products
YOU’RE FINISHED!
CIRCUIT BREAKER
ON/OFF SWITCH
ASSEMBLY STEP 5
FLAT WASHERS (B)
SPRING WASHERS (C)
BOLTS (G)
CONSOLE
HANDLEBAR BRACKET
RIGHT SIDE:
CONNECT CONSOLE
CABLES, PULSE CABLES
AND POWER CABLES
LEFT SIDE:
CONNECT PULSE
CABLES ONLY
FLAT WASHER (B)
8 mm
Qty: 4
SPRING WASHER (C)
8 mm
Qty: 4
BOLT (G)
16 mm
Qty: 4
A
B
C
D
E
F
G
ASSEMBLY STEP 6
FLAT WASHERS (B)
SPRING WASHERS (C)
BOLTS (A)
ARC WASHER (D)
SPRING WASHER (C)
BOLT (A)
SUPPORT BAR
MAIN FRAME
HANDLEBAR
Repeat on the other side.
A
B
C
D
E
F
FLAT WASHER (B)
8 mm
Qty: 4
SPRING WASHER (C)
8 mm
Qty: 6
ARC WASHER (D)
8 mm
Qty: 2
BOLT (A)
20 mm
Qty: 6
HARDWARE BAG 5 CONTENTS:
HARDWARE BAG 6 CONTENTS:
NOTE:
Do not completely tighten any bolts
until step 6 is complete!
Open HARDWARE BAG 5.
Place CONSOLE onto
HANDLEBAR BRACKETS
as shown.
NOTE:
Do not pinch
CONSOLE CABLE
when
placing the console onto the handlebar brack-
ets.
Insert 2 BOLTS (G), 2 SPRING WASHERS (C)
and 2 FLAT WASHERS (B) through the bottom
of the HANDLEBAR BRACKET to secure the
console to the
HANDLEBAR BRACKET.
Repeat on other side.
Reach inside the right underside of the
console to pull out the
CONSOLECABLE,
PULSECABLE
and
POWER CABLE.
Attach to
the matching cables that are hanging out of
the cable hole in the handlebar.
Repeat on left side to attach
PULSECABLE.
Thread attached cables back through the
cable holes when finished.
Open
HARDWARE BAG 6.
With the running deck in the lowered
position, place the
SUPPORT BAR
between the
HANDLEBAR
and the
MAIN FRAME.
To attach the
SUPPORT BAR,
insert
1
BOLT (A),
1
SPRING WASHER (C)
and 1
ARC WASHER (D)
in the top of
the
SUPPORT BAR
and 2
BOLTS(A),
2
SPRING WASHERS (C)
and 2
FLAT
WASHERS (B)
in the bottom of the
SUPPORTBAR
as shown.
Connect power plug to the treadmill
and connect the cord to a power
outlet. The on/off switch is located
next to the power cord. Flip this
switch to the 'ON' position, so that
the switch is lit. You will hear a
beep and the console will light up.
Before the first use, lubricate the
treadmill deck by following the
instructions in the Maintenance
section.
7
8
2/15/09 10:28 AM