Filter
Top Products
14
INTRODUCTION
IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
CONDITIONING
GUIDELINES
TROUBLESHOOTING
& MAINTENANCE
LIMITED
WARRANTY
15
INTRODUCTION
IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
CONDITIONING
GUIDELINES
TROUBLESHOOTING
& MAINTENANCE
LIMITED
WARRANTY
Open HARDWARE BAG 7.
Remove nylon nut, threaded screw and ball from end of CABLE B.
Route CABLE B through the pulley system in the RADIAL ARM ASSEMBLY as shown in
diagram.
After CABLE B routing is complete replace nylon nut, threaded screw and ball on end of
cable.
Hook HANDLES on to cable using the 2 HOOKS.
A
B
C
D
E
A S S E MB LY S TE P 8
CABLE B
Qty: 1
HARDWARE BAG 7 CONTENTS :
RUBBER STOP
BALL
NYLON NUT (C)
FLAT WASHER (B)
CABLE B
GRIP
HOOK
CLEVIS
FLAT WASHER (B)
SCREW (E)
Open HARDWARE BAG 8.
Remove nylon nut, threaded
screw and ball from end of
CABLE C.
Attach threaded cable end
to SINGLE FLOATING PULLEY
BRACKET.
Route CABLE C through pulley
system of BASE FRAME up
through the DUAL FLOATING
PULLEY BRACKET and back
to BASE FRAME and CENTER
SUPPORT FRAME as shown in
diagram.
After CABLE C routing is
complete replace nylon nut,
threaded screw and ball on end
of cable.
Hook the LEG ExTENSION/CURL
DOWN TUBE to the end of the
cable using the HOOK and the
ExTENSION CABLE.
A
B
C
D
E
F
A S S E MB LY S TE P 9
CABLE C
Qty: 1
HARDWARE BAG 8 CONTENTS :
RUBBER STOP
BALL
NYLON
NUT (C)
FLAT
WASHER (B)
HOOK
EXTENSION
CABLE
LEG EXTENSION/
CURL DOWN TUBE
CABLE SCREW
SINGLE FLOATING
PULLEY BRACKET
CABLE C
CLEVIS
FLAT WASHER (B)
SCREW (E)
S400_US_1.1.indd 14-15 8/31/07 10:10:40 AM