Filter
Top Products
BEFORE
YOU BEGIN
8
INTRODUCTION
IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
TREADMILL
OPERATION
LIMITED
WARRANTY
TROUBLESHOOTING
& MAINTENANCE
CONDITIONING
GUIDELINES
BEFORE
YOU BEGIN
ASSEMBLY
9
INTRODUCTION
IMPORTANT
PRECAUTIONS
TREADMILL
OPERATION
CONDITIONING
GUIDELINES
TROUBLESHOOTING
& MAINTENANCE
LIMITED
WARRANTY
A Open HARDWARE BAG 1.
B Connect CONSOLE WIRES.
C Slide CONSOLE MASTS over BASE
FRAME BRACKETS
.
D Insert BOLT (A) and FLAT WASHER
(B) into bottom side hole and
attach with NUT (C)
.
E Insert BOLT (D) and FLAT WASHER
(B) into rear hole.
F Repeat on other side.
G Insert BOLT (D) and FLAT WASHER
(B) into top side hole.
H Insert BOLT (D) into rear-most
inside hole.
I Repeat on other side.
NOTE: It is recommended that you apply grease to the threads of each bolt as you assemble your treadmill, to
prevent loosening and noise. Also, during each assembly step, ensure that ALL nuts and bolts are in place and
partially threaded in before completely tightening any ONE bolt.
PR E - AS S E MB LY
AS S E MB LY STE P 1
HARDWARE BAG 1 CONTENTS :
Steps A-C
Steps D-F
Steps G-I
A Open HARDWARE BAG 2.
B Slide CONSOLE MAST BOOTS
down over BASE FRAME
.
C Lift RUNNING DECK to upright
position.
D Insert 4 SCREWS (E) into inside
holes of CONSOLE MAST BOOTS
.
E Connect CONSOLE WIRES.
F Slide CONSOLE BRACKETS into
CONSOLE MAST as shown.
G To attach CONSOLE, insert
1 FLAT WASHER (F), 1 LOCK
WASHER (G) and 1 BOLT (D)
into
all 6 holes on upper
CONSOLE
MASTS.
AS S E MB LY STE P 2
HARDWARE BAG 2 CONTENTS :
PST6-PST8 Treadmill Rev 1.6.indd 8-9 7/25/05 1:49:41 PM