Filter
Top Products
BEFORE
YOU BEGIN
24
INTRODUCTION
IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
ELLIPTICAL
OPERATION
LIMITED
WARRANTY
TROUBLESHOOTING
& MAINTENANCE
CONDITIONING
GUIDELINES
ASSEMBLY
ELLIPTICAL
OPERATION
1) Select THR ZONE program using the PROGRAM SELECT keys and press ENTER.
• The HEART RATE window will flash showing the default target heart rate of 100 beats per minute.
Select your target heart rate (from the chart on page 26) using the ARROW KEYS and press ENTER.
*NOTE: Target beats per minute is selected in intervals of 5
2) Select WEIGHT using the ARROW KEYS and press ENTER.
3) Select TIME using the ARROW KEYS and press ENTER or START to begin the program.
NOTES:
1) There is a 4-minute warm-up built into this program at level 1 resistance.
2) After 4 minutes the resistance will automatically adjust to bring your heart rate within 5 beats of the
target number you selected at the beginning of the program.
3) If there is no Heart Rate detected, the unit will not change resistance levels up or down.
4) If your Heart Rate is 25 beats over your Target Zone the program will shut down.
S E L E C T I N G TH R ZO N E P R O G R A M