Filter
Top Products
BEFORE
YOU BEGIN
8
INTRODUCTION
IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
ELLIPTICAL
OPERATION
LIMITED
WARRANTY
TROUBLESHOOTING
& MAINTENANCE
CONDITIONING
GUIDELINES
BEFORE
YOU BEGIN
ASSEMBLY
9
INTRODUCTION
IMPORTANT
PRECAUTIONS
ELLIPTICAL
OPERATION
CONDITIONING
GUIDELINES
TROUBLESHOOTING
& MAINTENANCE
LIMITED
WARRANTY
BOLT (A)
FRONT STABILIZER TUBE
MAIN FRAME
A S S E M B LY ST E P 1
A) Open HARDWARE BAG FOR STEP 1.
B) Attach the FRONT STABILIZER TUBE to the MAIN FRAME using 2 BOLTS (A).
A S S E M B LY ST E P 2
MAIN FRAME
CONSOLE MAST
CONSOLE MAST BOOT
CONSOLE WIRES
BOLT (B)
SPRING WASHER (C)
FLAT WASHER (D)
BOLT (B)
SPRING WASHER (C)
ARC WASHER (E)
PRE-ATTACHED
ALIGNMENT BOLT
BOLT (B)
15 mm
Qty: 6
BOLT (F )
12 mm
Qty: 2
SPRING WASHER (C)
15 mm
Qty: 6
FLAT WASHER (D)
18 mm
Qty: 4
ARC WASHER (E)
17 mm
Qty: 2
angle view
HARDWARE BAG FOR STEP 2 CONTENTS :
WATER BOTTLE HOLDER
CONSOLE MAST
BOLTS (F)
BOLT (A)
20 mm
Qty: 2
HARDWARE BAG FOR STEP 1 CONTENTS :
Open HARDWARE BAG FOR STEP 2.
Remove PRE-ATTACHED ALIGNMENT BOLT from CONSOLE MAST.
Slide CONSOLE MAST BOOT onto the bottom of the CONSOLE MAST.
Put ALIGNMENT BOLT back into CONSOLE MAST, screwing it in only half way.
Carefully pull the CONSOLE WIRES through the CONSOLE MAST using the twist tie located inside the
CONSOLE MAST.
Attach the CONSOLE MAST to the MAIN FRAME using 6 BOLTS (B), 6 SPRING WASHERS (C),
4 FLAT WASHERS (D) and 2 ARC WASHERS (E).
DO NOT PINCH WIRES!
Attach the WATER BOTTLE HOLDER to the mast using 2 BOLTS (F).
A.
B.
C.
D.
E.
F.
G.
E900_E1200_Rev.2.5.indd 8-9 6/22/07 4:14:27 PM