Horizon Fitness CT12.1 Treadmill User Manual


 
5
TO REDUCE THE RISK OF BURNS, FIRE, ELECTRICAL SHOCK OR INJURY TO PERSONS:
At NO time should pets or children under the age of 13 be closer to the treadmill than 10 feet.
At NO time should children under the age of 13 use the treadmill.
Children over the age of 13 or disabled persons should not use the treadmill without adult supervision.
Use the treadmill only for its intended use as described in the treadmill guide and owner’s manual.
Do not use other attachments that are not recommended by the manufacturer. Attachments may cause injury.
Never operate the treadmill if it has a damaged cord or plug, if it is not working properly, if it has been dropped or damaged, or
immersed in water. Return the treadmill to a service center for examination and repair.
Keep power cord away from heated surfaces. Do not carry this unit by its supply cord or use the cord as a handle.
Never operate the treadmill with the air opening blocked. Keep the air opening clean, free of lint, hair, and the like.
To prevent electrical shock, never drop or insert any object into any opening.
Do not operate where aerosol (spray) products are being used or when oxygen is being administered.
To disconnect, turn all controls to the off position, then remove plug from outlet.
Do not use treadmill in any location that is not temperature controlled, such as but not limited to garages, porches, pool rooms,
bathrooms, car ports or outdoors. Failure to comply may void the warranty.
This treadmill is intended for in-home use only. Do not use this treadmill in any commercial, rental, school or institutional setting.
Failure to comply will void the warranty.
Do not remove the console covers unless instructed by Customer Tech Support. Service should only be done by an authorized
service technician
It is essential that your treadmill is used only indoors, in a climate controlled room. If your treadmill has been exposed to colder
temperatures or high moisture climates, it is strongly recommended that the treadmill is warmed up to room temperature before
first time use. Failure to do so may cause premature electronic failure.
WARNING