Filter
Top Products
BEFORE
YOU BEGIN
8
INTRODUCTION
IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
ELLIPTICAL
OPERATION
LIMITED
WARRANTY
TROUBLESHOOTING
& MAINTENANCE
CONDITIONING
GUIDELINES
BEFORE
YOU BEGIN
ASSEMBLY
9
INTRODUCTION
IMPORTANT
PRECAUTIONS
ELLIPTICAL
OPERATION
CONDITIONING
GUIDELINES
TROUBLESHOOTING
& MAINTENANCE
LIMITED
WARRANTY
A S S E M B LY ST E P 2
GUIDE RAIL CAPS
NOTE: There is NO hardware bag for this step.
A)
Slide GUIDE RAIL CAPS into the GUIDE RAIL
to seal the openings
.
WAVY WASHER (D)
CRANK
BOLT (G)WASHER (I)
WASHER (H)
RIGHT PEDAL ARM
RIGHT LINK ARM
FOOTPAD
LINK ARM
SCREWS (F)
WASHERS (S)
SPACER (R)
BOLT (T)
WASHER (U)
A S S E M B LY ST E P 3
WAVY WASHER (D)
CRANK
BOLT (G)WASHER (I)
WASHER (H)
RIGHT PEDAL ARM
RIGHT LINK ARM
FOOTPAD
LINK ARM
SCREWS (F)
WASHERS (S)
SPACER (R)
BOLT (T)
WASHER (U)
A) Open HARDWARE BAG FOR STEP 3.
B) Attach FOOTPAD to PEDAL ARM using 4 SCREWS (F).
C) Align the bracket on the RIGHT LOWER LINK ARM with the tube on the RIGHT PEDAL ARM.
D) Slide the SPACER (R) through the LINK ARM BRACKET and the PEDAL ARM so it can’t rotate.
E) Insert 2 WASHERS (S) between the PEDAL ARM and the LINK ARM BRACKET.
F) Secure the joint with 1 FLAT WASHER (U) and 1 BOLT (T).
G) Attach PEDAL ARM to the CRANK with 1 BOLT (G
)
, 1
WASHER (I),
1
WAVY WASHER (D)
and 1
WASHER (H).
H) Repeat on other side.
SCREW (F)
12 mm
Qty: 8
BOLT (G)
13 mm
Qty: 2
BOLT (T)
15 mm
Qty: 2
SPACER (R)
70 mm
Qty: 2
WASHER (H)
Qty: 2
WASHER (U)
35 mm
Qty: 2
WASHER (S)
30 mm
Qty: 4
WASHER (I)
Qty: 2
WAVY WASHER (D)
Qty: 2
angle view
HARDWARE BAG FOR STEP 3 CONTENTS :
CE6.0_Rev.1.3.indd 8-9 7/7/08 4:41:54 PM