Filter
Top Products
BEFORE
YOU BEGIN
8
INTRODUCTION
IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
ELLIPTICAL
OPERATION
LIMITED
WARRANTY
TROUBLESHOOTING
& MAINTENANCE
CONDITIONING
GUIDELINES
BEFORE
YOU BEGIN
ASSEMBLY
9
INTRODUCTION
IMPORTANT
PRECAUTIONS
ELLIPTICAL
OPERATION
CONDITIONING
GUIDELINES
TROUBLESHOOTING
& MAINTENANCE
LIMITED
WARRANTY
A S S E M B LY S T E P 2
A) Open HARDWARE BAG FOR STEP 2.
B) Slide left and right FOOT LEVELERS
onto MAIN FRAME.
C)
Attach FOOT LEVELERS using
WASHER (E)
and
BOLT (F).
HARDWARE BAG FOR STEP 2 CONTENTS :
A S S E M B LY S T E P 3
HARDWARE BAG FOR STEP 3 CONTENTS :
A) Open HARDWARE BAG FOR STEP 3.
B) Slide TEFLON SHEET WASHER (G),
PEDAL ARM
and TEFLON WASHER
(H) over PEDAL ARM BRACKET
C) Secure PEDAL ARM to PIVOT TUBE,
using NYLON NUT (I).
D) Attach PEDAL ARM COVER using
SCREW (J).
E) Repeat on other side.
A S S E M B LY S T E P 4
HARDWARE BAG FOR STEP 4 CONTENTS :
NOTE: There is NO hardware for steps
A-D. All hardware is pre-installed.
A) Remove PRE-ATTACHED BOLT &
WASHERS from CONSOLE MAST.
B) Slide LOWER HANDLEBAR onto
CONSOLE MAST and attach by re-
inserting PRE-ATTACHED BOLT &
WASHER.
C) Slide UPPER HANDLEBAR onto
LOWER HANDLEBAR and align
NOTCH with TAB making sure
handlebars are joined together
completely. Secure UPPER
HANDLEBAR to LOWER HANDLEBAR
using PRE-ATTACHED SET SCREWS.
D) Repeat on other side.
WARNING
After handlebars are assembled they will rotate freely – be cautious. Until the
machine is fully assembled, do not grab the handlebars for support.
E) Open HARDWARE BAG FOR STEP 4.
F) Attach FRONT & BACK HANDLEBAR
COVERS using 2 SCREWS (K) and 2
BOLTS (L) for each side.
4.2E ONLY
4.2E ONLY
4 . 2 E only
Elite 3.2E 4.2E Elliptical Rev 1.0.indd 8-9 7/13/05 2:47:56 PM