Filter
Top Products
Hobie Float Cat
Stripping Apron Assembly
(SEE ALSO: Large Diagrams Pg. 4)
Stripping Apron Parts List
Frame Rods:
J-1 fiberglass rod with hinge and ferrule
J-2 fiberglass rod with hinge and plain tip
Apron:
K-1 nylon storage bag with plastic hook and mesh
K-2 nylon storage bag with D ring
L two 7” aluminum apron support posts with molded
plastic C clamps
Hardware:
M four clevis pins with split rings
N two washers
O two eyebolts with nuts
P two Phillips head screws
Q two metal apron clips
Required tools: One large slot head screwdriver, one medium Phillips head screw driver
NOTE: Right and left references assumes a seated position facing aft.
Stripping Apron Assembly Instructions
STEP 1- Insert eyebolts (O) from outside seatback, through white
nylon bushings located on either side of seatback. Secure each with nuts. Eyebolts will spin freely in bushings.
STEP 2- Locate K1 and K2 and separate by undoing all Velcro edges and unhooking black plastic
hook on K1 from D ring on K2.
STEP 3- With Velcro edges completely unattached and bag facing zipper up, grasp K1 by grommeted tab and insert
ferrule end of J1 into the webbing sleeve along the curved edge of K1, bending rod as needed. Slide rod through sleeve
until grommeted tab can be inserted into hinge and lined up with the first hole (hole A) of hinge. Secure with clevis pin
and split ring. Repeat procedure with K2 and J2.
J1
K1
J2
K2
2
(SEE ALSO: Large Diagrams Pg. 4)