Filter
Top Products
8. See drawing 8a. Press the indicated tab and re-
move the guard from the console wire with
needlenose pliers. Discard the guard.
With the help of a second person, hold the Console
Assembly (91) near the Right Upright (54).
Remove the colored tie from the Wire Harness
(39). Connect the Wire Harness to the console
wire. Make sure to connect the connectors
properly (see drawing 8b). The connectors
should slide together easily and snap into
place. If they do not, turn one connector and try
again. IF THE CONNECTORS ARE NOT CON-
NECTED PROPERLY, THE CONSOLE MAY
BE DAMAGED WHEN THE POWER IS
TURNED ON. Insert the connectors and excess
wire into the Right Upright (54).
8
91
54
39
Console
Wire
9. Attach the Console Assembly (91) to the Right
Upright (54) and the Left Upright (53) with four
four Handrail Bolts (8) and four Handrail Star
Washers (5).
Make sure that no wires are
pinched. Start all four Handrail Bolts before
tightening them.
With the help of a second person, carefully lower
the Uprights (53, 54) to the floor.
9
8
8
5
5
91
54
53
39
9
7
. Set the Console Assembly (91) face-down on a
soft surface to avoid scratching the Console
Assembly. Hold the Right Handrail (33), which
has a large hole in the location shown, near the
C
onsole.
Next, insert the console wire into the hole in the
side of the Right Handrail (33). Using
needlenose pliers, pull the console wire out of
the hole near the bracket on the Right Handrail.
Then, set the Right Handrail (33) on the Console
Assembly (91).
Make sure that no wires are
pinched. Finger tighten a Crossbar Screw (85)
with a Crossbar Star Washer (7) into the Right
Handrail, and then start two Console Screws
(10) into the Right Handrail.
Tighten the
Crossbar Screw and then the two Console
Screws; do not overtighten the Screws.
Attach the Left Handrail (not shown) to the
Console Assembly (91) in the same way. Note:
There are no wires on the left side.
7
Console
W
ire
Large
Hole
33
B
racket
85
7
10
91
Guard
Tab
8b
8a
Console
Wire