Filter
Top Products
8
8. Have another person hold the Left Handlebar (24)
near the Upright (2) as shown. Connect the left Pulse
Sensor Wire (20) to the Pulse Extension Wire (101).
Slide an Axle Cover Endcap (91) onto the lower end of
the Left Handlebar.
Slide the upper end of the Left Handlebar (24) into the
tube on the front of the Upright (2), while sliding the
lower end of the Left Handlebar onto the Arm Axle
(19). Attach the upper end of the Left Handlebar with
two M8 x 42mm Button Bolts (85) and two M8 Nylon
Jam Nuts (86); be careful not to damage the Wires
(20, 101) as you insert the Button Bolts. Make sure
that the Jam Nuts are resting in the hexagonal
holes in the tube on the front of the Upright. Attach
the lower end of the Left Handlebar with an M8 x
35mm Button Bolt (105) and an M8 Jam Nut (86).
Press the tabs on the Axle Cover Endcap (91) into the
left Axle Cover (26).
Attach the Right Handlebar (23) to the Upright (2) in
the same way.
Hold the halves of the Handlebar Cover (25) around
the tube on the front of the Upright (2); be careful not
to damage the Wires (20, 101). Attach the Handlebar
Cover with an M4 x 16mm Round Head Screw (96).
24
20
101
91
19
86
Tab
105
8
85
96
23
25
2
86
31
Lubricate
7. Apply a small amount of the included Teflon
®
lubricant
to a paper towel. Rub a thin film of the lubricant onto
each Upper Body Leg (31).
Identify the Left Upper Body Arm (112), which is
marked with an “L” sticker. Slide the Left Upper Body
Arm onto the left Upper Body Leg (31). Slide the Right
Upper Body Arm (118) onto the right Upper Body Leg
(not shown).
Make sure that the Upper Body Arms
are on the correct sides. Next, slide an Axle Cover
(26) onto the post on each Upper Body Arm.
Apply grease to the Arm Axle (19). Insert the Arm Axle
into the Upright (2), the right Axle Cover (26), and the
Right Upper Body Arm (118). Next, push the Arm Axle
into the Upright until the left end of the Arm Axle is
flush with the left side of the Upright. Then, raise
the Left Upper Body Arm (112), and insert the Arm
Axle into the left Axle Cover (26) and the Left Upper
Body Arm. Center the Arm Axle and rotate it so the
indicated hole is in the position shown.
7
26
Hole
26
26
118
Grease
Post
112
19
2